ep

January 20, 2021

Energy UNITS FOR LIFT TABLE 1
Standard Description
This power unit is made solely for the little lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit is broadly employed while in the sector of logistic products including minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed from the solenoid valve using the velocity managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is intended solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, however the power provide is minimize, the decreasing motion is managed through the guide override function.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This power unit is created solely to the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the speed managed by a pressure compensated flow handle valve.
Energy UNITS FOR LIFT TABLE 4
Standard Description
This electrical power unit is built solely to the massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the velocity managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the energy supply is cut, the decreasing movement is controlled through the manual override function.
Distinctive Notes
one. This electrical power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic elements concerned in advance of set up of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities.N46 hydraulic oil is suggested.
4. Oil modifying is needed right after the first one hundred operation hrs,afterwards after every 3000 hours.
5. The electrical power unit proven is intended to be mounted vertically.