ep

January 18, 2021

General Description
Equipped with all the zero leak bidirectional checking sole-noid valves, this electrical power unit is created for your operation of two independent circuits. Which are respectively for the principal and subordinate platforms with the double scissors lift. Two cut-off valves are used for reducing the machine manually in case of energy reduction. If additional independent circuits are necessary for the application please contact us for availability.
Remark: 1. Please seek advice from our product sales engineer for your different pump displacement, motor power or tank capacity.
2. CSA or UL certified motors can be found on request.
Special Notes
one. The AC motor is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e., 1minute on and 9 minutes off.
2. Clean all of the hydraulic components concerned before set up of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,and the oil should be clean and cost-free of impurities,N46 hydraulic oil is recommended.
4. The energy unit must be mounted vertically.
5. Check the oil level from the tank immediately after the preliminary operating with the power unit.
six. Oil altering is needed after the first 100 operation hours,afterwards once each and every 3000 hours.