Select Page

Materials Handling Electrical power UNIT two
General Description
This energy unit options power up gravity down circuit. Activate the get started solenoid to begin the motor to lift the machine. The lowing movement is activated from the solenoid valve with all the lowering velocity controlled through the strain compensated flow management valve. Products of this series is usually widely used in the marketplace of logistic devices for example fork lift, mini lift table, and so on.
Particular Notes
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned in advance of mounting the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which should also be clean and cost-free of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is required right after the preliminary 100 operation hours,afterwards the moment just about every 3000 hours.
five. The electrical power unit need to be mounted horizontally.

Material Dealing with Energy UNIT 1
Basic Description
This power unit is built to the fork lift business, consisting of extremely effective gear pump, DC motor, manual raise and reduced valve, tank, ect. The up and down movement are controlled from the lever of your guide release valve, which can be outfitted with an electrical switch to activate the motor. The lowing pace is managed from the strain compensated flow handle valve.
Special Notes
1. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean every one of the hydraulic elements concerned ahead of set up of the energy unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which must also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
four. Oil altering is required immediately after the original one hundred operation hrs, afterwards the moment every 3000 hrs.
5. The energy unit shown is made to be mounted horizontally.